Simplicity 1690572 7117H Parts Manual
![Simplicity 1690572 7117H Tractor manual cover](/images/UBQEpABWvqphlbUaLddSbAKE/thumbs/thumb175x175.webp)
To perform regular maintenance, check the engine oil level and replace it if necessary, clean or replace the air filter, inspect the spark plug, and ensure the tires are properly inflated. Additionally, lubricate all moving parts and check the battery charge level.
If the tractor won't start, check the battery connections and charge the battery if needed. Ensure the spark plug is clean and properly connected. Also, verify that the fuel tank has sufficient fuel and that the fuel valve is open.
Uneven cutting can be caused by a dull or damaged blade, so check and sharpen or replace the blade if necessary. Ensure that the mower deck is level and the tire pressure is equal on all sides.
The Simplicity 1690572 7117H Tractor is designed to run on unleaded gasoline with an octane rating of 87 or higher. Avoid using gasoline with more than 10% ethanol content.
To change the oil, run the engine for a few minutes to warm it up, then turn it off. Remove the oil drain plug and allow the old oil to drain completely. Replace the drain plug, remove the oil filter, and install a new one. Finally, refill the engine with the recommended oil type and capacity.
If the tractor is overheating, check for debris blocking the air intake or cooling fins and clean them. Ensure the oil level is adequate and the oil is clean. Inspect the cooling system and radiator for leaks or blockages.
To adjust the cutting height, locate the height adjustment lever or knob, which is usually positioned near the driver's seat. Move the lever or turn the knob to the desired cutting height position. Ensure both sides are set equally for an even cut.
To winterize the tractor, add a fuel stabilizer to the fuel tank and run the engine for a few minutes to distribute it through the system. Clean the tractor thoroughly, remove the battery, and store it in a cool, dry place. Cover the tractor to protect it from dust and moisture.
The air filter should be checked every 25 hours of operation and replaced if it appears dirty or damaged. Under dusty conditions, it may require more frequent inspection and replacement.
Excessive vibration can be caused by an unbalanced or damaged blade, loose engine mounts, or worn pulleys. Check and balance or replace the blade, tighten engine mounts, and inspect pulleys for wear or damage.