Simplicity 1690106 Broadmoor 5010 Parts Manual
![Simplicity 1690106 Broadmoor 5010 Tractor manual cover](/images/FsCouQvrfTZUvRVXwpTezDAP/thumbs/thumb175x175.webp)
To change the oil, first run the engine for a few minutes to warm it up, which helps the oil drain better. Then, turn off the engine and disconnect the spark plug. Place a pan under the oil drain valve, open it, and let the oil drain completely. Replace the oil filter, close the valve, and refill the engine with the recommended type and quantity of oil as specified in the owner's manual.
If the tractor won't start, check the battery connections for corrosion or looseness. Ensure the fuel tank has fuel and the fuel valve is open. Inspect the spark plug for damage or fouling and replace it if necessary. Also, ensure the safety switches are engaged properly. If the problem persists, consult the manual for further troubleshooting steps or contact a professional service technician.
To adjust the cutting height, locate the height adjustment lever or knob on the tractor. Move the lever or turn the knob to the desired cutting height position, typically measured in inches. Make sure the mower deck is level from side to side for an even cut.
Before storing the tractor for winter, clean the tractor and mower deck to remove grass clippings and debris. Change the oil and oil filter, and top off the fuel tank with fuel stabilizer added. Inflate the tires to the recommended pressure and disconnect the battery to prevent discharge. Store the tractor in a dry, covered area.
To replace the drive belt, first disconnect the spark plug and remove the mower deck. Release the belt tension using the idler pulley and remove the old belt from the pulleys. Install the new belt by routing it around the pulleys according to the diagram in the manual, ensuring it is properly seated in the grooves. Reattach the mower deck and reconnect the spark plug.
Excessive vibration can be caused by an unbalanced or damaged blade, loose hardware, or worn bearings. Inspect the blades for damage or imbalance and replace if necessary. Check and tighten any loose bolts or nuts, and inspect the bearings for wear or damage, replacing them if needed.
The Simplicity 1690106 Broadmoor 5010 Tractor typically requires clean, fresh, unleaded gasoline with an octane rating of 87 or higher. Avoid using fuel with high ethanol content, as it may cause engine damage.
Uneven cutting can result from a misaligned mower deck, dull blades, or uneven tire pressure. Check that the mower deck is level and adjust if necessary. Sharpen or replace the blades if they are dull. Also, ensure all tires are inflated to the recommended pressure.
To clean the air filter, remove it from the engine and tap it gently to remove loose dirt. If it's a foam filter, wash it with warm soapy water, rinse thoroughly, and allow it to dry completely before reinstalling. For a paper filter, replace it if it's excessively dirty or damaged.
Check the spark plug at the start of each mowing season and replace it if it's worn, dirty, or damaged. Typically, the spark plug should be replaced every 100 hours of operation or annually, whichever comes first. Use a spark plug recommended in the owner's manual for optimal performance.