Simplicity 1690007 Broadmoor 5010 Parts Manual
![Simplicity 1690007 Broadmoor 5010 Tractor manual cover](/images/beclqcYyAtuamYSRENRtcald/thumbs/thumb175x175.webp)
For the Simplicity 1690007 Broadmoor 5010 Tractor, it is recommended to use SAE 30 oil for temperatures above 32°F and 5W-30 for temperatures below 32°F. Always refer to the owner's manual for the most accurate information.
Regular maintenance should be performed every 25 hours of operation or annually, whichever comes first. This includes checking the oil, air filter, and spark plug, as well as general inspection of belts and blades.
Check the battery connections to ensure they are clean and tight. Verify that there is fuel in the tank and the fuel valve is open. Inspect the spark plug for wear or damage and replace if necessary.
To adjust the mowing deck height, locate the height adjustment lever on the side of the tractor. Move the lever to the desired position, ensuring that all four corners of the deck are level.
To winterize your tractor, drain the fuel tank, change the oil, remove the battery, and store it in a cool, dry place. Clean the tractor thoroughly and cover it to protect it from dust and moisture.
If your tractor is running rough, it may be due to a dirty air filter, bad spark plug, or old fuel. Inspect these components and clean or replace them as necessary.
The recommended tire pressure for the Broadmoor 5010 is typically around 10-14 PSI for the front tires and 8-10 PSI for the rear tires. Always check the tire sidewall for specific recommendations.
To replace the drive belt, first disconnect the spark plug for safety. Remove the mower deck and then the belt guards. Carefully remove the old belt and install the new one following the belt routing diagram. Reassemble all parts after ensuring the belt is properly seated.
If the blades are not engaging, check the mower deck belt for wear or damage and ensure it is properly tensioned. Also, inspect the PTO switch and wiring connections.
For electrical issues, start by checking the battery for charge and clean connections. Inspect fuses and replace any that are blown. Ensure that all wiring harnesses are connected securely and there are no visible signs of damage.