Opel Vivaro 2013.5 Owner’s Manual
![Opel Vivaro 2013.5 manual cover](/images/56c0fa1d574085e87dc873ca/thumbs/thumb175x175.webp)
To reset the service light, turn the ignition key to position II without starting the engine. Press the accelerator and brake pedals together, and hold them for approximately 15 seconds. The service light should begin to flash and then disappear.
The recommended engine oil type for the Opel Vivaro 2013.5 is 5W-30 fully synthetic oil, which meets the ACEA C3 specification. Always check the owner’s manual for any specific requirements for your engine model.
First, check the A/C fuse and relay for any faults. Ensure the refrigerant level is adequate. If these components are functioning correctly, inspect the compressor and the A/C belt for wear or damage. Consider seeking professional diagnostics if the issue persists.
The recommended tire pressure for the Opel Vivaro 2013.5 is typically around 36 PSI (2.5 bar) for both front and rear tires. However, it’s essential to check the label inside the driver's door frame for precise specifications.
To replace the headlight bulb, open the bonnet and locate the back of the headlight assembly. Remove the protective cover, disconnect the power connector, and release the retaining clip. Replace the old bulb with a new one, ensuring it is securely in place, then reassemble.
Common causes of starting issues include a weak or dead battery, faulty starter motor, or a defective ignition switch. Additionally, check for any fuel delivery issues, such as a clogged fuel filter.
The timing belt on an Opel Vivaro 2013.5 should typically be replaced every 60,000 miles or 5 years, whichever comes first. Always refer to the maintenance schedule in the owner's manual for specific intervals.
To check the brake fluid level, locate the brake fluid reservoir under the bonnet. Ensure the vehicle is on a level surface and the engine is off. The fluid level should be between the 'MIN' and 'MAX' marks on the reservoir. Top up if necessary, using the recommended brake fluid type.
To improve fuel efficiency, ensure regular maintenance such as timely oil changes, air filter replacements, and maintaining correct tire pressure. Additionally, avoid excessive idling, reduce unnecessary weight, and drive at a steady speed.
If the engine warning light illuminates, check for any obvious issues such as low oil or coolant levels. If no immediate concerns are found, it’s advisable to have a diagnostic scan performed by a professional to identify and address any underlying issues.