Milwaukee Rechargeable 250L 2010R Operator's Manual

To charge the Milwaukee 250L 2010R Light, use the included USB charging cable. Connect it to a USB power source and plug the other end into the light's charging port. The indicator light will turn red to show charging and green when fully charged.
First, ensure the light is fully charged. If it still does not turn on, try resetting the light by holding the power button for 10 seconds. If the issue persists, check for any visible damage or contact Milwaukee customer support.
To switch between light modes, press the power button repeatedly. The light will cycle through its available modes, including high, low, and strobe.
The Milwaukee 250L 2010R Light has a runtime of approximately 3 hours in high mode when fully charged.
Yes, the Milwaukee 2010R Light can be used while it is charging, although it may take longer to reach a full charge.
Regularly clean the light with a soft, dry cloth to remove dust and debris. Avoid using harsh chemicals. Store the light in a cool, dry place when not in use, and charge it every few months to maintain battery health.
Check that the USB cable is properly connected to both the power source and the light. Try using a different cable or power source. If the indicator still does not light up, the charging port may be faulty, and you should contact Milwaukee support.
Yes, the Milwaukee 2010R Light is rated IP54, meaning it is protected against dust and splashes of water from any direction. However, it should not be submerged in water.
The Milwaukee 2010R Light has a built-in rechargeable battery that is not user-replaceable. If you experience battery issues, contact Milwaukee for service options.
The Milwaukee 2010R Light comes with a limited warranty. Check the documentation provided with the product or contact Milwaukee for specific warranty terms and conditions.