Milwaukee M18 Switch Tank 49-16-28CS Operator's Manual
![Milwaukee M18 Switch Tank 49-16-28CS Sprayer manual cover](/images/MheNyLVlaWCFIaSrolXAfxaA/thumbs/thumb175x175.webp)
To assemble the sprayer, first attach the tank to the backpack frame. Ensure the tank is securely locked in place. Connect the hose to the tank and attach the spray wand to the hose. Finally, insert the M18 battery into its compartment.
After use, empty any remaining liquid from the tank. Fill the tank with clean water and run the sprayer until the water runs clear to flush out any residue. Remove the nozzle and clean it separately.
First, check if the battery is charged and properly inserted. Ensure that the tank is filled with liquid and the hose is not kinked or clogged. Inspect the nozzle for blockages and clean if necessary.
To extend battery life, fully charge the battery before use and avoid depleting it completely. Store the battery in a cool, dry place when not in use. Regularly clean the battery contacts to ensure a good connection.
Regularly inspect the sprayer for leaks or damage. Clean all components after each use, especially the nozzle and filters. Check hoses and seals for wear and replace them if necessary. Store the sprayer in a dry place.
Yes, the sprayer can handle bleach solutions. However, after using bleach, it is essential to thoroughly rinse the tank, hose, and nozzle with clean water to prevent damage and residue buildup.
Adjust the spray pattern by twisting the nozzle tip. This allows you to switch between a fine mist and a direct stream, depending on your application needs.
Always wear protective gear, such as gloves and goggles, when handling chemicals. Ensure the sprayer is in good working condition and avoid spraying against the wind to prevent inhalation of chemicals.
Loss of pressure can be due to a clogged nozzle, a kinked hose, or a low battery. Clean the nozzle, check for hose obstructions, and ensure the battery is fully charged.
To replace the hose, first disconnect it from the tank and the spray wand. Attach the new hose to the tank, ensuring a secure fit. Connect the other end to the spray wand, checking for leaks after assembly.