Mazda 6 Sports Sedan 2007 Maintenance Schedule Manual
![Mazda 6 Sports Sedan 2007 manual cover](/images/fe78c91bfb3df24bc17f6762/thumbs/thumb175x175.webp)
To reset the tire pressure monitoring system, first ensure that all tires are inflated to the recommended pressure. Turn the ignition to the ON position without starting the engine. Press and hold the tire pressure monitoring system reset button (located under the dashboard) until the TPMS indicator light blinks twice. Release the button and turn off the ignition.
The 2007 Mazda 6 Sports Sedan is recommended to use SAE 5W-20 engine oil. It's important to use oil that meets Mazda's quality standards, which includes API Service SM or ILSAC GF-4.
First, check the fuse for the air conditioning system. If the fuse is intact, examine the refrigerant level; low levels can prevent the system from cooling. Also, inspect the AC compressor and ensure it's engaging when the AC is turned on. If these steps don't resolve the issue, a professional inspection might be necessary.
First, park the vehicle on a level surface and apply the parking brake. Place wheel chocks behind the wheels. Loosen the lug nuts slightly before jacking up the car. Use the provided jack to lift the car, then remove the lug nuts and the flat tire. Mount the spare tire, hand-tighten the lug nuts, lower the car, and then fully tighten the nuts in a crisscross pattern.
The 2007 Mazda 6 with a V6 engine uses a timing chain, which typically does not require replacement. However, if you have a 4-cylinder engine, it uses a timing belt, which should be inspected at approximately 60,000 miles and replaced around 100,000 miles or as specified in the owner's manual.
The recommended tire pressure for the 2007 Mazda 6 Sports Sedan is typically 32 psi for both the front and rear tires. Always refer to the sticker on the driver's side door jamb for the most accurate information.
Open the glove box and remove the damper by pulling it off the pin. Squeeze the sides of the glove box to release the stops and lower the glove box completely. You'll see the cabin air filter cover behind the glove box. Remove the cover, take out the old filter, and insert the new one. Replace the cover and reassemble the glove box.
Poor fuel efficiency can be caused by several factors, including under-inflated tires, dirty air filters, faulty oxygen sensors, or bad spark plugs. Ensure regular maintenance is performed, such as oil changes and air filter replacements, and check for any diagnostic trouble codes with an OBD-II scanner.
Start the engine and let it warm up to normal operating temperature. With the engine idling, shift through each gear, pausing in each one. Then, put the car in Park and let it idle. Locate the transmission dipstick, remove it, and wipe it clean. Reinsert the dipstick fully, then remove it again to check the fluid level. The fluid should be within the marked range on the dipstick.
A squealing noise upon starting the engine is often due to a loose or worn serpentine belt. Inspect the belt for signs of wear or damage and check the tension. If the belt is in poor condition, it may need to be replaced. Adjusting the tensioner might also resolve the issue.