Lincoln Town Car 2005 Owner's Manual
![Lincoln Town Car 2005 Sedan manual cover](/images/RUalZjFLaIMSvqAaOjliNKDG/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the 'ON' position without starting the engine. Press the 'RESET' button located on the instrument panel until 'OIL LIFE RESET' is displayed. Hold the 'RESET' button for about 2 seconds until the display reads '100%'. The oil change light is now reset.
The recommended engine oil for a 2005 Lincoln Town Car is 5W-20. It is important to use oil that meets Ford specification WSS-M2C153-H.
Start by checking the air suspension switch in the trunk to ensure it's turned on. Inspect the air suspension fuse and relay in the engine compartment fuse box. If those are functional, listen for the air compressor running when the car is started. If the compressor is silent, it may need replacement.
To replace the cabin air filter, first locate the filter housing under the hood, near the windshield on the passenger side. Remove the retaining screws and the cover. Slide out the old filter and insert the new one, ensuring it is oriented correctly. Replace the cover and screws.
Insert the ignition key and turn it from 'OFF' to 'RUN' eight times, ending in 'RUN' within 10 seconds. The doors will lock and unlock to confirm programming mode. Press any button on the new remote, and the doors will lock and unlock to confirm the programming. Turn the ignition to 'OFF' to exit programming mode.
Common causes of overheating include a malfunctioning thermostat, low coolant levels, a failing water pump, or a clogged radiator. Regular maintenance checks can help identify and prevent these issues.
It is recommended to change the transmission fluid every 30,000 to 60,000 miles. Always refer to the owner's manual for the manufacturer's specific recommendations.
The recommended tire pressure for a 2005 Lincoln Town Car is typically 32 PSI for both front and rear tires. Always check the tire placard located on the driver’s side door pillar for the most accurate information.
To replace the headlight bulb, open the hood and locate the headlight assembly. Remove the cover from the back of the headlight, then twist the bulb socket counterclockwise and pull it out. Detach the old bulb and attach the new one, avoiding touching the glass. Reinsert the bulb socket and replace the cover.
At 100,000 miles, it's recommended to replace the spark plugs, inspect the timing belt, check and replace fluids as necessary, inspect the suspension system, and perform a thorough inspection of the braking system.