Lincoln Navigator 2008 Owner's Manual
![Lincoln Navigator 2008 SUV manual cover](/images/AuVdooosSwnYWCWlxPKbWhGr/thumbs/thumb175x175.webp)
The 2008 Lincoln Navigator typically requires 5W-20 synthetic blend oil. Always refer to the owner’s manual for confirmation.
It is recommended to replace the air filter every 15,000 to 30,000 miles, but check it more frequently if you drive in dusty conditions.
The 2008 Lincoln Navigator has a towing capacity of up to 9,000 pounds when properly equipped.
To reset the TPMS, turn the ignition to the on position without starting the engine, press and hold the TPMS reset button until the tire pressure light blinks three times, and then release it. Drive the vehicle for a few minutes to complete the reset.
The recommended tire pressure for the 2008 Lincoln Navigator is typically 35 PSI for both front and rear tires. Check the tire placard located on the driver's door jamb for confirmation.
To replace a headlight bulb, open the hood, locate the back of the headlight assembly, disconnect the electrical connector, remove the old bulb by turning it counterclockwise, and install the new bulb by turning it clockwise. Reconnect the electrical connector.
If the engine overheats, turn off the air conditioning, turn on the heater to maximum, and pull over safely. Turn off the engine and wait for it to cool before checking the coolant level. Do not open the radiator cap while the engine is hot.
To improve fuel efficiency, ensure regular maintenance such as oil changes, proper tire inflation, and clean air filters. Additionally, avoid aggressive driving and reduce excess weight in the vehicle.
Follow the maintenance schedule outlined in the owner’s manual, which typically includes oil changes every 5,000 miles, tire rotation every 7,500 miles, and brake inspection every 10,000 miles.
To program a new key fob, insert the existing key into the ignition and turn it to the on position eight times within 10 seconds, ending in the on position. The door locks will cycle, indicating programming mode. Press any button on the new key fob to program it. Turn the ignition off to exit programming mode.