Kamigami Scarrax Robot FRC95 Instruction Manual

To connect the Scarrax Robot to your mobile device, ensure that Bluetooth is enabled on your device. Open the Kamigami app, tap on "Connect Robot," and select your Scarrax Robot from the list of available devices.
First, check that the batteries are fully charged and installed correctly. Next, ensure that the robot's legs and other mechanical parts are not obstructed by dirt or debris. If the problem persists, try resetting the robot by turning it off and on again.
Connect your robot to the Kamigami app. If a firmware update is available, the app will prompt you to update. Follow the on-screen instructions to complete the update process.
In the Kamigami app, navigate to the "Code" section. Use the visual programming interface to drag and drop commands to create new behaviors. Once satisfied, upload the program to your robot and test the new behaviors.
To perform a factory reset, press and hold the reset button located on the underside of the robot for about 10 seconds until the lights flash. This will restore the robot to its original settings.
Regularly check for dirt or debris in the robot's joints and legs. Clean the robot with a dry cloth to prevent dust buildup. Ensure the batteries are charged and stored in a cool, dry place when not in use.
While the Scarrax Robot can be used outdoors on flat, smooth surfaces, it is not waterproof and should be kept away from water and wet conditions. Avoid using it on rough or uneven terrain to prevent damage.
Check to ensure the batteries are correctly installed and fully charged. If the robot still doesn't turn on, try replacing the batteries with new ones. If the issue continues, contact customer support for further assistance.
To improve battery life, turn off the robot when not in use and ensure it is fully charged before use. Avoid overcharging by unplugging the charger once the batteries are fully charged.
Ensure that your mobile device's Bluetooth is turned on and that you are within range. Restart the app and attempt to reconnect. If the problem persists, restart both the robot and your mobile device.