Indesit Innex BDE 861483X S UK N Quick Guide

To start a wash cycle, load your laundry, add detergent, close the door, select the desired program using the control knob, and press the 'Start/Pause' button.
Ensure the machine is plugged in and switched on. Check the door is fully closed, and the water supply is turned on. Make sure the 'Start/Pause' button has been pressed.
Remove the detergent drawer by pulling it out gently. Rinse it under warm water to remove any detergent residue. Use a soft brush if needed. Dry it before reinserting.
The "F05" error indicates a problem with the drain pump. Check for blockages in the filter and drain hose. Ensure the pump is not obstructed. If the issue persists, consult a technician.
It is recommended to clean the filter every month to ensure optimal performance and prevent blockages.
Leave the door open after each wash to allow the drum to dry. Run a maintenance wash with hot water and a specialized cleaner once a month.
Ensure the machine is level and all feet are in contact with the floor. Avoid overloading the drum. Distribute laundry evenly inside the drum before starting the cycle.
Check if you've selected the correct drying program. Ensure the lint filter is clean, and the load is not too large. Adjust settings if necessary.
Yes, you can use the combined wash and dry program. Load the machine, select the combined cycle, and press 'Start/Pause' to begin.
To reset the washer dryer, turn off the machine, unplug it, wait for a few minutes, and then plug it back in and restart the cycle.