Hummer H3T 2010 Owner's Manual
![Hummer H3T 2010 manual cover](/images/QvUxAxdGcrpMBVnISBTCobCg/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The oil light should flash, indicating the reset is complete.
The recommended tire pressure for the Hummer H3T 2010 is typically 35 psi for both front and rear tires. Always refer to the sticker on the driver's side door jamb for exact specifications.
To improve fuel efficiency, ensure regular maintenance such as oil changes and air filter replacements. Keep tires properly inflated, reduce excess weight, and drive at moderate speeds.
The Hummer H3T 2010 typically requires 5W-30 synthetic oil for optimal performance. Check the owner's manual for specific recommendations.
First, check the AC fuse and replace if necessary. Ensure the refrigerant level is adequate. If the issue persists, it may require professional diagnosis of the compressor or other system components.
The towing capacity of the Hummer H3T 2010 is approximately 5,900 pounds when properly equipped. Always consult the owner's manual and ensure proper towing equipment is used.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the bulb cover, disconnect the wiring harness, and replace the old bulb with a new one. Reconnect the harness and secure the bulb cover.
The check engine light can be triggered by various issues, such as a loose gas cap, faulty oxygen sensor, or engine misfire. Use an OBD-II scanner to retrieve error codes and diagnose the problem.
It's recommended to replace the air filter every 15,000 to 30,000 miles, or as specified in the owner's manual. If you frequently drive in dusty conditions, consider replacing it more often.
Common causes of battery drain include leaving lights or accessories on, a faulty alternator, or parasitic drain from electrical components. Perform a battery test and check for any electrical issues.