GMC Savana 2020 Owner's Manual
![GMC Savana 2020 manual cover](/images/pzUrJIEYtGsSvVyEkQHPOhkt/thumbs/thumb175x175.webp)
To reset the oil life monitor on a 2020 GMC Savana, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal three times within five seconds. The oil life system will reset when the display shows 100%.
The recommended tire pressure for the 2020 GMC Savana typically ranges from 50 to 80 psi for the rear tires and around 50 psi for the front, depending on the model and load. Always refer to the placard located on the driver’s side door jamb for the exact specifications.
If the air conditioning system is not working properly in your GMC Savana 2020, check the refrigerant level, examine the fuses and relays related to the AC system, inspect the AC compressor, and ensure that the cabin air filter is clean. Consult the owner's manual or a professional technician if these steps do not resolve the issue.
For the 2020 GMC Savana, it is recommended to use SAE 5W-30 full synthetic engine oil. Make sure to select oil that meets the GM dexos1 specification. Always check the owner's manual for the most accurate recommendations.
To replace the cabin air filter on a 2020 GMC Savana, first locate the filter housing under the dashboard on the passenger side. Remove the cover by undoing the fasteners, slide out the old filter, and insert a new filter. Ensure the airflow direction matches the arrows on the filter housing. Replace the cover securely.
A rough idle in your GMC Savana 2020 could be caused by dirty fuel injectors, a faulty oxygen sensor, a dirty air filter, or spark plug issues. Inspect these components and replace or clean as necessary. If the problem persists, consult a certified mechanic for further diagnosis.
To engage the tow/haul mode on a 2020 GMC Savana, locate the button on the end of the gear shift lever. Press the button to activate the mode, which will adjust the transmission shift patterns for better towing performance. An indicator light on the dashboard will confirm activation.
If the check engine light illuminates in your 2020 GMC Savana, check for any obvious issues such as a loose gas cap. If the light remains on, use an OBD-II scanner to read the diagnostic trouble codes (DTCs). Address the issues indicated by the codes and consult a mechanic if necessary.
To jump-start a 2020 GMC Savana, park a vehicle with a good battery close by. Connect the positive jumper cable to the positive terminals of both batteries, then the negative cable to the negative terminal of the good battery and a metal ground on the Savana. Start the assisting vehicle, then the Savana. Once started, carefully remove the cables in reverse order.
The towing capacity of the 2020 GMC Savana can vary based on the engine and configuration but generally ranges from 7,400 to 10,000 pounds. It is important to consult the owner's manual or the manufacturer's specifications to determine the exact towing capacity for your specific vehicle setup.