GMC Envoy 2007 Getting To Know Your Manual
![GMC Envoy 2007 manual cover](/images/wUQznHeDLRSraRBzWOWyFwRZ/thumbs/thumb175x175.webp)
The recommended oil type for a 2007 GMC Envoy is 5W-30.
To reset the 'change oil' light, turn the ignition key to the "ON" position without starting the engine. Fully press and release the accelerator pedal three times within five seconds. The 'change oil' light should flash then go out, indicating it has been reset.
The 2007 GMC Envoy has a towing capacity of up to 5,800 pounds when properly equipped.
First, open the hood and locate the headlight assembly. Remove the retaining clips or screws. Disconnect the power connector from the bulb, then remove the old bulb. Insert the new bulb without touching the glass, reconnect the power connector, and reattach the assembly.
Common issues include low refrigerant levels, a faulty compressor, or a clogged cabin air filter. Check these components and consider having a professional perform a system diagnostic if the problem persists.
Common issues include hard shifting, slipping gears, and delayed response. Regular transmission fluid changes and inspections can help prevent these problems.
It is recommended to change the spark plugs every 100,000 miles under normal driving conditions.
The check engine light can be triggered by various issues, including a loose gas cap, faulty oxygen sensor, or catalytic converter problems. Use an OBD-II scanner to read the trouble codes for a specific diagnosis.
Connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the good battery. Connect the negative cable to the negative terminal of the good battery and the other end to an unpainted metal surface on the engine block of the dead vehicle. Start the engine of the good vehicle, then the dead vehicle.
The recommended tire pressure for a 2007 GMC Envoy is typically 30 PSI for both front and rear tires. Check the placard on the driver's side doorjamb for confirmation.