GE DD700 GDP645SYNFS Installation Instructions

To reset the GE DD700 GDP645SYNFS dishwasher, press and hold the "Start/Reset" button for about 3 seconds until the control panel lights turn off. Wait a few minutes, and the dishwasher should reset.
If the dishwasher does not start, check if the door is properly closed, ensure that the dishwasher is plugged in, and verify that the circuit breaker has not tripped. Also, make sure the "Start" button is pressed and held firmly.
To clean the filter, remove the bottom dish rack, twist and pull out the cylindrical filter at the bottom of the dishwasher, and rinse it under running water. Ensure all debris is removed before placing it back.
Unusual noises can be caused by items being loose in the dishwasher, such as utensils hitting each other or the spray arms. Ensure dishes are properly loaded and check for any blockages in the spray arms.
If the dishwasher is not draining, check the drain hose for kinks, ensure the sink's drain is clear, and clean the dishwasher's filter. You may also need to check the drain pump for blockages.
It's recommended to clean the dishwasher filter and check for debris monthly. Additionally, run a cleaning cycle with a dishwasher cleaner every 1-3 months to maintain performance.
No, you should not use regular dish soap as it can cause excessive suds and overflow. Use only detergent specifically designed for dishwashers.
Spots can be caused by hard water. Ensure you are using a rinse aid, and check that the water temperature is at least 120°F for optimal cleaning. You may also consider using a water softener.
To improve drying, use a rinse aid, ensure that the "Heated Dry" option is selected, and avoid overcrowding the dishwasher. Opening the door slightly after the cycle can also help air-dry the dishes.
Regular maintenance includes cleaning the filter monthly, checking and cleaning the spray arms, inspecting the door seal for debris, and running a cleaning cycle with a dishwasher cleaner every 1-3 months.