GE AZ45 AZ45E07DAB Installation Instructions

Ensure that the air conditioner is securely mounted in a window or wall opening that is appropriately sized. Follow the installation instructions in the manual, making sure the unit is level and that there is no obstruction to airflow.
Check if the air filter is clean and not blocked. Ensure that the thermostat is set to the desired temperature. Also, make sure windows and doors are closed properly to prevent warm air from entering the room.
The air filter should be checked every 30 days and cleaned if necessary. If the filter is damaged or excessively dirty, it should be replaced following the instructions in the user manual.
Clean the unit thoroughly, remove and clean the filter, and cover the air conditioner with a suitable cover to protect it from dust and debris. It is also advisable to disconnect power and ensure the unit is dry.
Unusual noises may be due to loose parts, debris in the fan area, or an unbalanced unit. Inspect these areas and tighten any loose components. If the noise persists, consult a professional technician.
Ensure that the unit is properly sealed in the installation area to prevent air leaks. Regularly clean the air filter, and use energy-saving settings or timers to reduce energy consumption when full cooling is not necessary.
Check if the unit is tilted properly to allow condensation to drain outside. Make sure the drain pan is not clogged and the drainage system is functioning. Clean as necessary to ensure proper water flow.
Turn off the air conditioner using the control panel or remote. Wait a few minutes, then turn it back on. If it doesn’t reset, unplug the unit for a few minutes before plugging it back in and turning it on.
The filter reset light indicates that it's time to check and clean the air filter. After cleaning, press the reset button on the unit (refer to the manual for its location) to turn off the light.
First, replace the batteries in the remote control. Ensure there are no obstructions between the remote and the unit. If the problem persists, try resetting the remote by removing the batteries, pressing all buttons, and then reinstalling the batteries.