Clarke 8675000 DG6000DVES Instructions

To start the generator, ensure the fuel valve is open, the choke is in the correct position (closed for cold start), and the battery is charged. Then, turn the key in the electrical starter or use the recoil starter for manual ignition.
This generator runs on diesel fuel. Ensure you use clean, fresh diesel to maintain optimal performance and prevent engine issues.
Change the oil after the first 20 hours of operation, and then every 100 hours or annually, whichever comes first. Use high-quality, manufacturer-recommended oil.
Check the fuel level, oil level, and battery charge. Ensure the spark plug is in good condition and clean. Verify that the choke is in the correct position and the fuel valve is open.
Regularly check the battery terminals for corrosion and clean as needed. Ensure the battery is charged and check electrolyte levels, topping up with distilled water if necessary.
Drain the fuel system, change the oil, remove the battery and store it in a cool, dry place. Cover the generator to protect it from dust and moisture.
Check all connections and make sure the load is within the generator's capacity. Inspect circuit breakers and fuses. If issues persist, consult the manual or a professional technician.
Regularly check and clean the air filter, change the oil, inspect and clean the spark plug, and ensure all nuts and bolts are tight. Perform a general inspection for leaks and wear.
Locate the circuit breaker on the control panel and switch it to the 'off' position, then back to the 'on' position to reset it. Ensure the generator is not overloaded.
No, it is not recommended to use the generator in wet or rainy conditions to avoid electrical hazards and damage. Always operate in a dry, well-ventilated area.