Clarke 7230693 PSP105 250W Puddle Auto Sensor Instructions

To install the Clarke 7230693 PSP105 Puddle Pump, ensure it's placed on a flat surface in the area to be drained. Connect the discharge hose to the pump outlet and ensure the power cable is safely plugged into a suitable outlet.
If the pump does not start, check the power supply and ensure the plug is properly connected. Verify that the auto sensor is not obstructed and the water level is sufficient for activation.
To clean the pump, disconnect it from the power supply, remove it from the water, and clean any debris from the inlet screen. Rinse with clean water to ensure no clogs remain.
The Clarke 7230693 PSP105 Puddle Pump is designed to handle water temperatures up to 35°C. Ensure the water temperature does not exceed this limit to avoid damage.
Check for blockages in the inlet or discharge hose, ensure the pump is fully submerged, and inspect the impeller for any damage or debris.
The pump is suitable for clean or slightly dirty water. It is not designed for use with sewage or chemical-laden water.
The auto sensor activates the pump when the water level reaches a certain height and turns it off when the level falls below the sensor, preventing dry running.
Regularly inspect the pump for visible damage, clean the inlet screen monthly, and perform a full inspection every six months to ensure optimal performance.
The pump is not recommended for saltwater use as it may lead to premature wear and corrosion. Use only with fresh water for best results.
If the pump is making unusual noises, check for debris in the impeller or inlet, ensure the pump is securely positioned, and inspect for any signs of wear or damage.