Chrysler 200 2015 Owner's Manual
![Chrysler 200 2015 Sedan manual cover](/images/mejmJyQkVKhVReaXXOQpbSVY/thumbs/thumb175x175.webp)
The recommended oil type for the 2015 Chrysler 200 Sedan is SAE 0W-20 for vehicles equipped with a 2.4L engine and SAE 5W-20 for those with a 3.6L engine.
To reset the TPMS on a 2015 Chrysler 200, ensure that all tires are properly inflated, then drive the vehicle above 15 mph (24 km/h) for at least 10 minutes to allow the system to update.
To jump-start your 2015 Chrysler 200, connect the positive cable to the positive terminals of both batteries, then connect the negative cable to the negative terminal on the assisting vehicle's battery and an unpainted metal surface on your vehicle. Start the assisting vehicle, then your Chrysler 200.
To replace the cabin air filter, locate the filter housing behind the glove compartment. Open the glove compartment, remove the limiting stop arm, push inwards on the sides to drop it fully, and access the filter housing to replace the old filter with a new one.
Common issues with the 2015 Chrysler 200's transmission include rough shifting, hesitation, and transmission failure. Regular maintenance and software updates can help mitigate some of these issues.
To pair your smartphone, activate Bluetooth on your device, press the 'Phone' button on the Uconnect system, select 'Pair a Device', and choose your vehicle from the list on your phone. Enter the PIN shown on the Uconnect screen if prompted.
If the check engine light comes on, ensure the gas cap is tightened. If the light remains lit, use a diagnostic tool to check for error codes or visit a certified mechanic for a thorough inspection.
Spark plugs on the 2015 Chrysler 200 should generally be replaced every 100,000 miles, but it's advisable to check them regularly for wear and replace them earlier if necessary.
The 2015 Chrysler 200 Sedan is not specifically designed for towing, and Chrysler does not recommend towing with this vehicle model.
To change the headlight bulb, access the back of the headlight assembly by removing the front wheel and inner fender liner. Twist and remove the old bulb from the socket, replace it with a new one, and reassemble the components.