Chevrolet Uplander 2007 Owner's Manual
![Chevrolet Uplander 2007 manual cover](/images/snkwcNLAYcqGxUCUWlXWgjKI/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The light should flash and then reset.
The 2007 Chevrolet Uplander requires DEXRON-VI automatic transmission fluid for optimal performance.
Locate the cabin air filter under the passenger side dashboard. Remove the cover by unscrewing the screws. Slide out the old filter and replace it with a new one, ensuring the airflow direction is correct. Reattach the cover.
Common causes of overheating include low coolant levels, a faulty thermostat, a clogged radiator, or a malfunctioning water pump. Check the coolant level and inspect these components for issues.
Insert the key into the ignition and turn it to the "On" position. Press and hold the "Lock" and "Unlock" buttons on the remote for about 15 seconds until the locks cycle, confirming programming.
The recommended tire pressure for the 2007 Chevrolet Uplander is typically 35 psi for both front and rear tires. Check the vehicle's door placard for specific details.
Open the hood and locate the headlight assembly. Remove the screws securing the headlight housing, then gently pull it out. Disconnect the electrical connector and replace the bulb. Reinstall the housing and secure it with screws.
Check the battery connections for corrosion, ensure the battery is charged, and inspect the starter and ignition system. A faulty fuel pump or clogged fuel filter may also prevent starting.
With the engine warm and idling, open the hood and locate the transmission dipstick. Pull it out, wipe it clean, reinsert it, and then remove it again to check the fluid level. Add fluid if necessary.
Common triggers for the check engine light include a loose gas cap, faulty oxygen sensor, malfunctioning catalytic converter, or a problematic mass airflow sensor. A diagnostic scan tool can identify specific issues.