Chevrolet Silverado 2008 Owner's Manual
![Chevrolet Silverado 2008 manual cover](/images/FnawTLuozxnCyWwOIghQXauS/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal fully three times within five seconds. The oil change light should flash and then turn off, indicating it has been reset.
The recommended tire pressure for the 2008 Chevrolet Silverado is typically 30-35 PSI for both front and rear tires. Always check the driver’s side door jamb for the specific tire pressure recommendations for your vehicle.
To improve fuel efficiency, ensure regular maintenance such as oil changes and air filter replacements. Keep tires properly inflated, avoid excessive idling, and drive at steady speeds using cruise control when possible.
For the 2008 Chevrolet Silverado, it is recommended to use 5W-30 engine oil. Make sure to choose oil that meets the GM6094M standard for best performance.
First, check the refrigerant levels and ensure they are adequate. Inspect the A/C compressor for proper operation and check for any leaks in the system. If the problem persists, a professional diagnostic may be necessary.
If the check engine light comes on, check for loose or damaged hoses and ensure the gas cap is tightened properly. If the light remains on, use an OBD-II scanner to read the trouble codes, or visit a professional mechanic for diagnosis.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the connector and turn the bulb counterclockwise to remove it. Insert the new bulb and secure it by turning it clockwise, then reconnect the connector.
The towing capacity of the 2008 Chevrolet Silverado varies depending on the engine and configuration. It ranges from approximately 4,400 to 10,500 pounds. Always refer to the owner’s manual for specific towing capacities for your vehicle.
To program a new key fob, insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the "Unlock" button on the driver’s door while inserting and removing the key from the ignition twice. Release the "Unlock" button, and the doors should lock and unlock, indicating the vehicle is in programming mode. Press and hold the "Lock" and "Unlock" buttons on the new key fob until the door locks cycle.
Regular maintenance for the 2008 Chevrolet Silverado includes oil changes every 3,000-5,000 miles, tire rotations every 6,000 miles, and brake inspections every 12,000 miles. Refer to the owner’s manual for a detailed maintenance schedule.