Chevrolet Prizm 2002 Owner's Manual
![Chevrolet Prizm 2002 manual cover](/images/SjDTQJDgnQbsvkqJovXfxGhr/thumbs/thumb175x175.webp)
To replace the air filter, locate the air filter box near the front of the engine bay. Release the clips or screws holding the cover in place, remove the old filter, and insert a new one ensuring it is seated properly. Reattach the cover and secure it.
The recommended oil type for a 2002 Chevrolet Prizm is 5W-30. It's best to use high-quality, API-certified oil for optimal engine performance.
Engine overheating could be due to low coolant levels, a faulty thermostat, a malfunctioning water pump, or a clogged radiator. Check these components and ensure there are no leaks in the cooling system.
Check the battery connections for corrosion, ensure the battery is charged, and test the starter and alternator. If these components are functional, verify that the fuel system and ignition system are operating correctly.
The timing belt should be replaced every 60,000 to 90,000 miles. Consult the owner's manual for specific recommendations based on driving conditions and vehicle usage.
Poor fuel efficiency can be caused by a dirty air filter, incorrect tire pressure, clogged fuel injectors, or a malfunctioning oxygen sensor. Regular maintenance can help prevent these issues.
To reset the check engine light, you can disconnect the battery for about 15 minutes. If the light persists, use an OBD-II scanner to diagnose and clear the codes.
The recommended tire pressure is typically 30-32 psi for both front and rear tires. Verify the exact specifications in the vehicle's manual or on the tire placard located on the driver's doorjamb.
A squealing noise when braking is often caused by worn brake pads. Inspect the brake pads and replace them if necessary. Also, check for any debris caught between the brake pads and rotors.
To replace a headlight bulb, open the hood and locate the back of the headlight assembly. Remove the dust cover, disconnect the electrical connector, and release the retaining clip to remove the old bulb. Insert the new bulb, secure it with the clip, reconnect the connector, and replace the dust cover.