Chevrolet Malibu 2007 Owner's Manual
![Chevrolet Malibu 2007 manual cover](/images/bzoWhOMIFYqEBtdmhJXOAOAX/thumbs/thumb175x175.webp)
To reset the oil change light, turn the ignition key to the "ON" position without starting the engine. Fully depress the accelerator pedal three times within five seconds. The light should flash and then turn off, indicating the reset was successful.
The recommended engine oil for a 2007 Chevrolet Malibu is 5W-30. It's important to use oil that meets GM Standard GM6094M for optimal performance and protection.
Start by checking the refrigerant level and ensure there are no leaks. Verify that the AC compressor is engaging and inspect the fuses and relays related to the AC system. If the problem persists, it may require a professional diagnostic.
Common transmission issues include slipping gears, delayed shifting, and unusual noises. Regular maintenance, such as checking and replacing the transmission fluid, can help prevent these issues.
Open the key fob by using a flathead screwdriver to gently pry it apart. Remove the old battery and replace it with a new CR2032 battery, ensuring the positive side faces up. Snap the fob halves back together.
The recommended tire pressure for a 2007 Chevrolet Malibu is typically 30 PSI for both front and rear tires. Check the tire placard located on the driver's side door jamb for the exact specifications.
Locate the cabin air filter behind the glove box. Remove the retaining clips and lower the glove box to access the filter compartment. Slide out the old filter and insert the new one, ensuring it is positioned correctly.
If the check engine light comes on, check for any obvious issues like a loose gas cap. If no immediate issues are found, use an OBD-II scanner to read the error codes. Address the specific problems indicated by the codes.
To improve fuel efficiency, ensure regular maintenance like oil changes and air filter replacements. Keep tires properly inflated, drive at steady speeds, and reduce excess weight in the vehicle.
To remove minor scratches, wash and dry the area, then apply a small amount of scratch remover polish with a microfiber cloth. Buff the area in a circular motion, then clean and wax the area to protect the finish.