Chevrolet Express 2019 Owner's Manual
![Chevrolet Express 2019 manual cover](/images/dIHhRCHOLfUCFqEVEGeChNsR/thumbs/thumb175x175.webp)
To reset the oil life monitor, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The oil life percentage should reset to 100%.
The recommended engine oil for a 2019 Chevrolet Express Van is SAE 5W-30. Make sure to use oil that meets the GM dexos1™ specification.
To pair your phone, turn on the vehicle and enable Bluetooth on your phone. Use the van's infotainment system to search for devices. Select your phone from the list and confirm the pairing code on both devices.
The towing capacity of a 2019 Chevrolet Express Van is up to 10,000 pounds, depending on the configuration and engine. Always refer to the owner's manual for specific towing information.
To replace the air filter, locate the air filter housing under the hood. Remove the cover by unclipping the fasteners. Take out the old filter and insert the new one, ensuring it is seated properly. Reattach the cover securely.
The recommended tire pressure for a 2019 Chevrolet Express Van is typically 50 PSI for the front tires and 80 PSI for the rear tires. Check the tire placard on the driver's door for the most accurate information.
To jump-start the van, connect the positive cable to the positive terminal of the dead battery and the other end to the positive terminal of the booster battery. Connect the negative cable to the negative terminal of the booster battery and the other end to an unpainted metal surface on the van. Start the booster vehicle, then the Express Van.
To disable the seatbelt chime, consult the vehicle's manual for the specific procedure. In some cases, the chime can be disabled by connecting a seatbelt extender or through dealership programming.
Common causes of a check engine light include a loose gas cap, faulty oxygen sensor, or a malfunctioning catalytic converter. Use an OBD-II scanner to determine the specific error code, or visit a mechanic for diagnosis.
To change the windshield wipers, lift the wiper arm away from the windshield. Press the tab on the wiper blade to release it from the arm. Slide the new wiper blade onto the arm until it clicks into place. Lower the arm back onto the windshield.