Chevrolet Express 2017 Owner's Manual

To reset the oil life monitor, turn the ignition to the "ON" position without starting the engine. Press the accelerator pedal to the floor three times within five seconds. The oil life monitor should reset and show 100%.
The recommended tire pressure for the 2017 Chevrolet Express Van is typically 50 psi for the front tires and 80 psi for the rear tires. It's important to check the tire placard located on the driver's side door jamb for exact specifications.
If the check engine light is on, use an OBD-II scanner to read the trouble code. This will help identify any issues with the engine or emissions system. Address the specific issue indicated by the code, which may require professional assistance.
The recommended oil type for the Chevrolet Express 2017 Van with a V8 engine is 5W-30 synthetic oil. Always refer to the owner's manual for the most accurate information.
First, check the fuses related to the HVAC system. If fuses are intact, inspect the refrigerant level and ensure there are no leaks. If these are not the issues, it may require professional diagnosis and repair.
It is recommended to change the transmission fluid every 45,000 miles under normal operating conditions. Check the owner's manual for specific intervals based on your driving habits.
The towing capacity of the Chevrolet Express 2017 Van varies depending on the engine and configuration, but it can tow up to 10,000 pounds when properly equipped. Refer to the owner's manual for exact specifications.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, ensuring not to touch the glass with bare hands, and reassemble.
Common causes of a rough idle include dirty fuel injectors, a clogged air filter, faulty spark plugs, or vacuum leaks. Cleaning or replacing these components may resolve the issue.
Insert the original key into the ignition and turn it to the "ON" position. Within five seconds, insert the new key and turn it to "ON." Wait for the security light to turn off, indicating successful programming.