Chevrolet Equinox 2009 Owner's Manual

To reset the oil life monitor, turn the ignition to the "ON" position without starting the engine. Press the "INFO" button until "OIL LIFE" is displayed. Then, press and hold the "INFO" button until the display shows 100%.
The recommended tire pressure for the 2009 Chevrolet Equinox is typically 35 PSI for both front and rear tires. Always check the sticker on the driver's side door jamb for the most accurate information.
To replace the headlight bulb, first open the hood. Locate the back of the headlight assembly and remove the bulb cover. Twist and remove the old bulb and replace it with a new one. Ensure it is securely in place before replacing the cover.
The 2009 Chevrolet Equinox typically requires SAE 5W-30 engine oil. Always refer to your owner’s manual to verify the correct oil type for your specific vehicle model.
A squeaking noise when braking could indicate worn brake pads or a lack of lubrication on the brake components. Inspect the brake pads for wear and replace them if necessary. Ensure all moving parts are properly lubricated.
To program a new key fob, insert the key and turn the ignition to "ON". Press and hold the "LOCK" and "UNLOCK" buttons on the key fob simultaneously until the vehicle chimes. Turn the ignition to "OFF" and test the new key fob.
The check engine light can be triggered by various issues, including a loose gas cap, faulty oxygen sensor, or issues with the catalytic converter. A diagnostic scan tool can help identify the exact cause.
To improve fuel efficiency, ensure regular maintenance such as oil changes and air filter replacements, maintain proper tire pressure, and avoid aggressive driving habits. Consider using fuel system cleaners periodically.
A burning smell could be caused by oil or coolant leaks, or electrical issues. Inspect the engine for any visible leaks or burnt wires, and address any issues promptly to prevent further damage.
To replace the cabin air filter, locate the filter housing under the dashboard on the passenger side. Remove the cover and take out the old filter. Insert the new filter, ensuring it is oriented correctly, and replace the cover.