Cadillac SRX 2010 Convenience & Personalization Guide
![Cadillac SRX 2010 manual cover](/images/WqqPHBXShDZvMUcqtkvRtLho/thumbs/thumb175x175.webp)
To reset the oil life monitor on a 2010 Cadillac SRX, turn the ignition to the "ON" position without starting the engine. Press the "INFO" button on the steering wheel until "OIL LIFE" is displayed. Then, press and hold the "SET/RESET" button until the display shows 100%.
The recommended oil for a 2010 Cadillac SRX is 5W-30 synthetic oil. Always check the owner's manual for specific recommendations and ensure you use oil that meets GM's dexos1 specification.
To pair your phone with the Bluetooth system, press the "CONFIG" button on the console, select "Phone Settings," then "Bluetooth" and "Pair Device." Follow the prompts on the display and your phone to complete the pairing process.
The recommended tire pressure for a 2010 Cadillac SRX is typically 35 PSI for both front and rear tires. Always check the sticker located on the driver's side door jamb for the most accurate information.
To replace the cabin air filter, locate the filter housing under the hood near the windshield. Remove the cover by loosening the screws or clips, take out the old filter, and insert a new one. Ensure the airflow direction matches the arrow on the filter.
A whining noise during acceleration could be caused by several issues, including a worn serpentine belt, failing alternator, or transmission problems. It's recommended to have a professional mechanic diagnose the exact cause.
To jump-start a 2010 Cadillac SRX, connect the positive cable to the positive terminal of the dead battery, then to the positive terminal of the booster battery. Connect the negative cable to the negative terminal of the booster battery, then to an unpainted metal surface on the SRX. Start the booster vehicle, then the SRX.
If the check engine light illuminates, check for any obvious issues such as a loose gas cap. If the problem persists, have the vehicle's computer scanned for diagnostic trouble codes (DTCs) to determine the underlying issue.
To program a new key fob, insert the existing key and turn it to the "ON" position. Remove the key and insert the new fob within 10 seconds, then turn to "ON." The vehicle should recognize the fob. Consult the owner's manual for detailed steps, as some models may require dealer programming.
Spark plugs in a 2010 Cadillac SRX should typically be replaced every 100,000 miles. However, it's a good idea to check them every 30,000 miles for wear or damage. Always use the recommended spark plug type specified in the owner's manual.