Cadillac Escalade ESV 2008 Convenience & Personalization Guide
![Cadillac Escalade ESV 2008 manual cover](/images/qhRygxHthJMyrUPPROhTbyAN/thumbs/thumb175x175.webp)
The recommended engine oil for the Cadillac Escalade ESV 2008 is SAE 5W-30. It's important to use oil that meets the GM6094M standard for optimal performance.
To reset the TPMS, turn the ignition to the ON position without starting the engine. Press and hold the TPMS reset button until the tire pressure light blinks three times, then release the button. Drive the vehicle for a few minutes to allow the system to reset.
The 2008 Cadillac Escalade ESV has a towing capacity of up to 7,800 pounds when properly equipped. Always consult the owner's manual for specific towing guidelines and limitations.
Improving fuel efficiency can be achieved by maintaining proper tire pressure, performing regular maintenance such as oil changes and air filter replacements, and avoiding aggressive driving behaviors.
Common issues include problems with the air suspension system, faulty door handles, and electrical issues such as dashboard light malfunctions. Regular inspections can help prevent these issues.
To change the cabin air filter, locate the filter housing under the passenger side dashboard. Remove the cover and old filter, then insert the new filter and replace the cover. Consult the owner's manual for detailed instructions.
The recommended tire pressure for the 2008 Cadillac Escalade ESV is typically 35 PSI for both front and rear tires. Always check the tire placard located on the driver’s side door jamb for the most accurate information.
It is recommended to change the transmission fluid every 50,000 to 60,000 miles. However, refer to the owner's manual for specific intervals based on driving conditions and vehicle usage.
To jump-start the vehicle, connect the positive cable to the positive terminal of the dead battery, then to the positive terminal of the booster battery. Connect the negative cable to the negative terminal of the booster battery and the other end to a metal ground on the vehicle. Start the booster vehicle, then the Escalade.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the electrical connector and turn the bulb counterclockwise to remove it. Insert the new bulb, turn it clockwise to secure, and reconnect the electrical connector.