Burstner Elegance 2016 Instruction Manual
![Burstner Elegance 2016 manual cover](/images/vkQKFroushNTvgGztERTzOpL/thumbs/thumb175x175.webp)
To reset the trip computer, navigate to the trip computer menu on the dashboard display. Select the 'Reset' option using the steering wheel controls, and confirm the reset by pressing the OK button.
The recommended engine oil for the Burstner Elegance 2016 is a synthetic 5W-30 oil that meets the manufacturer's specifications. Always check the owner's manual for the exact requirements.
First, check the fuse for the water pump. If it is intact, inspect the pump for any visible damage or loose connections. Ensure the water tank has sufficient water and that the system is not airlocked.
The correct tire pressure is typically listed on a sticker located on the driver's side door frame. It usually ranges from 55-60 PSI depending on the load. Always refer to the manufacturer's guidelines.
Regularly clean the roof with a mild detergent and water. Inspect for any signs of damage or leaks and apply a UV-protection sealant annually to prolong the life of the roof material.
Maintain a steady speed, avoid excessive idling, and keep up with regular maintenance like oil changes and air filter replacements. Proper tire inflation also contributes to better fuel efficiency.
Check that the refrigerator is switched to the correct power source (electric or gas). Ensure there is adequate ventilation around the fridge and that the vents are not blocked. Clean the burner and check for gas flow if using propane.
Drain all water from the tanks, pipes, and water heater. Add RV antifreeze to the plumbing system. Disconnect and store the battery in a dry, warm place. Cover vents and windows to prevent moisture ingress.
Locate the brake fluid reservoir under the hood. Ensure the vehicle is on a level surface. Check the fluid level against the markings on the reservoir. If low, top up with the recommended type of brake fluid.
Use the air suspension control panel usually located near the driver's seat. Adjust the height settings according to the load and terrain. Ensure the system is set to the 'Drive' mode before moving the vehicle.