Beko BCFD350 User Manual
![Beko BCFD350 manual cover](/images/ycdQFvvzWAdJOJnLOPntoDiw/thumbs/thumb175x175.webp)
To adjust the temperature settings on the Beko BCFD350, locate the thermostat dial inside the fridge compartment. Turn the dial to the desired setting, with higher numbers indicating colder temperatures.
If your Beko BCFD350 is not cooling properly, first check that the thermostat is set correctly. Ensure the door seals are clean and free from obstruction. Also, verify that the fridge is not overloaded and that air vents are not blocked.
You should defrost the Beko BCFD350 freezer compartment whenever the frost build-up exceeds 3-5 mm or at least once every six months to maintain efficiency.
Unusual noises from the Beko BCFD350 can be caused by the appliance being unlevel, items inside the fridge vibrating, or the compressor cycling. Ensure the appliance is level, rearrange items to prevent vibration, and check that the unit is not touching the wall.
To clean the condenser coils on the Beko BCFD350, first unplug the appliance. Locate the coils at the back or bottom of the unit and use a vacuum cleaner with a brush attachment to gently clean away dust and debris.
The ideal temperature setting for the Beko BCFD350 fridge compartment is between 3°C and 5°C, while the freezer compartment should be set to -18°C for optimal food preservation.
To replace the light bulb in the Beko BCFD350 fridge, unplug the appliance, remove the light cover inside the fridge, unscrew the old bulb, and replace it with a new one of the same type and wattage.
If the Beko BCFD350 is leaking water, check the drainage hole at the back of the fridge compartment for blockages. Clear any debris and ensure the drain pan is not overfilled.
To improve energy efficiency, ensure the Beko BCFD350 is placed in a cool location away from heat sources, keep the door seals clean and intact, and avoid overloading the fridge or blocking air vents.
Yes, the door swing on the Beko BCFD350 can be reversed. Refer to the user manual for detailed instructions or contact a qualified technician to perform this task.