Beko B5T4923IW User Manual

To reset your Beko B5T4923IW washing machine, unplug it from the power source, wait for about 2-3 minutes, and then plug it back in. This should reset the machine’s electronics.
Ensure the door is closed properly and the power supply is connected. Check if the start/pause button has been pressed and verify there are no error codes displayed.
Remove the detergent drawer by pulling it out gently and pressing the release latch. Wash it under warm water and use a soft brush to remove any residue. Dry it thoroughly before reinserting.
Ensure the washing machine is level on the ground and that all transit bolts have been removed. Check that the load is balanced inside the drum.
Open the filter cover, usually located at the bottom front of the machine. Turn the filter counterclockwise to remove it, clean it under running water, and replace it securely.
The E5 error code indicates a water heating issue. Check if the water heater is functioning correctly and ensure the water supply is at the correct temperature. Contact a technician if the issue persists.
Leave the door open after each wash to allow the drum to dry, and run a monthly maintenance wash with a washing machine cleaner or vinegar to prevent build-up.
Regularly clean the detergent drawer, drum, and door seal. Check and clean the filter monthly and ensure there is no residue build-up in any part of the machine.
Pause the cycle, open the door, and redistribute the items evenly in the drum. Remove or add items to balance the load if necessary.
Check the drain hose for blockages and ensure it is positioned correctly. Clean the filter and make sure the pump is not obstructed.