Acura TL 1997 Owner's Manual
![Acura TL 1997 Sedan manual cover](/images/VXnJtcBSlLlMaYKkOBOZIgAd/thumbs/thumb175x175.webp)
To reset the maintenance light, insert the key into the ignition and turn it to the "II" position. Press and hold the "Select/Reset" button on the instrument panel. While holding the button, turn the ignition switch back to the "I" position. Continue holding the button until the maintenance light turns off.
For a 1997 Acura TL, it is recommended to use 5W-30 or 10W-30 viscosity motor oil. Ensure the oil meets the API certification of SJ or later.
Common reasons for engine overheating include low coolant levels, a faulty thermostat, a malfunctioning radiator fan, or a clogged radiator. Check these components and ensure your coolant is at the proper level.
Locate the air filter housing in the engine bay. Unclip or unscrew the cover to access the air filter. Remove the old filter and replace it with a new one, ensuring it fits snugly. Re-secure the housing cover.
Possible causes for starting issues include a dead battery, faulty starter motor, or a bad ignition switch. Check the battery voltage and connections, and test the starter and ignition components.
To check the transmission fluid, start the engine and let it warm up. Park the car on a level surface and locate the transmission dipstick. Pull it out, wipe it clean, reinsert it, and then remove it again to check the fluid level. The fluid should be within the marked range on the dipstick.
The ABS light may be on due to a malfunctioning wheel speed sensor, low brake fluid, or a faulty ABS module. Inspect these components and consult a professional if necessary.
First, lift the car and remove the wheel to access the brake caliper. Remove the caliper bolts and take off the caliper, being careful not to damage the brake line. Remove the old brake pads and install new ones. Reattach the caliper and wheel, then repeat on the other side.
The recommended tire pressure for a 1997 Acura TL is typically 30-32 PSI for both front and rear tires. Check the owner's manual or the sticker inside the driver's door for specific recommendations.
Start by checking the fuses and relays related to the malfunctioning system. Inspect the battery terminals and wiring for corrosion or damage. Use a multimeter to test for continuity and voltage at various points in the circuit.