Acura NSX 1998 Owner's Manual
![Acura NSX 1998 Sports Car manual cover](/images/nsQQSIkOgiKDFnEaeWKOHTnC/thumbs/thumb175x175.webp)
The 1998 Acura NSX requires SAE 10W-30 motor oil. The oil capacity is approximately 5.3 quarts (5.0 liters) with a filter change.
It is recommended to replace the timing belt every 60,000 miles or every 6 years, whichever comes first, to ensure optimal engine performance and prevent potential damage.
The correct tire pressure for the 1998 Acura NSX is 33 psi for the front tires and 40 psi for the rear tires. Always refer to the owner's manual or the tire placard for the most accurate information.
Check the coolant level and ensure there are no leaks. Inspect the radiator and hoses for blockages or damage. Also, verify that the thermostat is functioning properly and that the cooling fans are operating.
Common causes include interior lights left on, faulty alternator, parasitic electrical draw, or a defective battery. Perform a thorough check to identify the root cause.
To reset the maintenance required light, turn the ignition switch to the ON position without starting the engine. Press and hold the trip button, then turn the ignition switch to the OFF position. Continue holding the button and turn the ignition back to ON until the light turns off.
Use Honda Premium Formula Automatic Transmission Fluid (ATF) for automatic transmissions. For manual transmissions, use Honda Manual Transmission Fluid or SAE 10W-30 or 10W-40 motor oil.
To improve fuel efficiency, ensure regular maintenance such as air filter and spark plug replacement, maintain proper tire pressure, and drive at moderate speeds. Avoid rapid acceleration and excessive idling.
The recommended brake pads for a 1998 Acura NSX are OEM replacement pads. Ensure they are designed to fit the specific caliper type and rotor dimensions of the NSX. Consult the owner's manual for specific part numbers.
Start by checking the fuses and relays for any signs of damage or blown components. Inspect the battery terminals and wiring for corrosion or loose connections. Use a multimeter to test for continuity and proper voltage levels in suspect circuits.